Home
  Secret button and flashing LED.

 
   
 
    Top picture: Secret buttons interrupts starter solenoid. Connect as needed.

Bottom picture: The LED needs to flash when the car is not running. Connect the positive end of the LED (with 150 ohm resistor in series) to wire to "hot at all times" and negative side to "hot when ignition on."

"Check that the LED flashes when the ignition is off and stops flashing when the key is turned (ignition on). "

Parts needed:

  1. 1 flashing LED
  2. one 150 ohm resistor
  3. one grommet (for LED mount)

LED contributed by: Dan Kelly (dpkelly@mobility.com).